This is the MACPUMP version of a hand pump. It will fully inflate a 260Q in two strokes. I was thinking restaurant work when I made this one.
Maintenance and care of the Table Top Pump
To clean your Table Top Pump remove the nylon screw at the top of the 3” cylinder and lift the center pole out (you may have to lift moderately hard to separate the pump). Now with a clean cloth or paper towel wipe off the valve assembly and O ring. Check O ring for ware if worn out replace the O ring (available from macpump.net)
If O ring is okay use a light amount of Vaseline on the O ring. Wipe out the cylinder with a clean cloth or paper towel. Once the cylinder is clean place a small amount of Vaseline around the inside of the 3” cylinder below the air intake hole.
Reassemble the pump by place the center pole, valve assembly first into the 3” cylinder. The center pole should be inserted at a slight angel take care NOT to pinch the O ring. Once inserted into cylinder straighten and replace cap aligning air intake hole and threaded hole and replace nylon screw. You should now be ready to go.
This is the MACPUMP version of a hand pump. It will fully inflate a 260Q in two strokes. I was thinking restaurant work when I made this one.